index

SACFT200 Fiberglass Coated Facing Tissue to Eliminate Paint Bleeding and Improve Board Rigidity in Gypsum and Wall Insulation Panels

2026-11-16 11:46

1. Technical Overview


SAXOBRAN SACFT200 is a heavy-duty wet-laid non-woven fiberglass coated facing tissue engineered for continuous gypsum board casting and rigid thermal insulation board lamination lines. 

We manufacture this pre-coated fiberglass tissue using a specialized calcium carbonate mineral coating formulation to seal surface porosity, stop slurry bleed-through, and provide a smooth, paint-ready finish. 

The 200g/m² coated matrix maintains dimensional flatness under high-temperature board drying kilns up to 220°C. 

Wallboard and insulation factories feed SACFT200 directly onto gypsum slurry, PIR/PUR foam, and rock wool cores to boost board bending strength, eliminate loose glass dust, and improve exterior weather resistance.


Fiberglass Coated Facing Tissue


2. Technical Specifications Table (TDS)


Technical ParameterMetric ValueTest StandardWorkshop Function & Purpose
Unit Weight (Grammage)200 g/m² (±5%)ISO 3374Controls exact fiberglass tissue and mineral coat mass to prevent gypsum slurry bleed-through
Nominal Thickness0.70 mm (±0.10)ISO 534Provides rigid structural skin thickness to boost finished board impact and bending resistance
MD Tensile Strength≥ 350 N/50mmISO 3342Prevents web stretching and line snaps under high pull tension on fast board-casting lines
CD Tensile Strength≥ 250 N/50mmISO 3342Stops edge tearing and width shrinkage during wide-web unwinding and board edge folding
Moisture Content≤ 1.0%ISO 3344Eliminates steam blistering, surface pinholes, and facing delamination during kiln drying


3. Key Features & Workshop Problem Solvers


Stops Gypsum Slurry and Foam Bleed-Through on High-Speed Lines

Uncoated glass veils allow wet gypsum slurry or liquid polyurethane foam to bleed through the surface, staining the board face and fouling forming rollers. SACFT200 fiberglass coated facing tissue features a dense, calibrated calcium carbonate mineral coating. It seals surface pores completely while bonding tightly to the wet core on the underside, keeping forming belts clean and producing uniform white boards.


Eliminates Fiber Dust and Delivers a Paint-Ready Surface

Standard fiberglass facers release loose glass fibers during jobsite cutting and require heavy primer coats before architectural painting. SACFT200 fiberglass tissue locks every glass filament inside a smooth, non-chalking mineral skin. Installers cut and fasten boards cleanly without skin irritation, and painters apply topcoats directly with low paint consumption.





Related News

Read More >
Get the latest price? We'll respond as soon as possible(within 12 hours)
  • Required and valid email address
  • This field is required
  • This field is required
  • This field is required
  • This field is required